Midea outdoor heat pump condenser installed at a Metro Vancouver home — 360 Install Solution

    Full Electric Heat Pump Installation

    Go fully electric with a central ducted heat pump — no gas required. The cleanest, most efficient way to heat and cool your entire home through existing ductwork.

    Is This Right for You?

    Here are the most common situations where homeowners choose this system.

    Replacing a gas furnace entirely

    Eliminate your gas bill and carbon footprint. A full electric heat pump handles both heating and cooling through your existing ducts.

    Homes with existing ductwork

    If you already have ducts from a furnace or AC system, switching to a ducted heat pump is straightforward and cost-effective.

    New construction or major renovation

    Building new or gutting to the studs? Design your system around an all-electric heat pump from day one.

    Maximizing CleanBC rebates

    Full electric conversions from gas typically qualify for the highest available rebates in BC.

    Key Benefits

    Zero Emissions On-Site

    No gas combustion, no CO risk, no fossil fuel dependency. 100% electric operation.

    300% Efficient

    Heat pumps move heat rather than create it — delivering up to 3x more energy than they consume.

    Heating + Cooling

    One system replaces both your furnace and AC. Heats in winter, cools in summer.

    Highest Rebates

    Gas-to-electric conversions typically qualify for the largest available BC rebates.

    Quieter Operation

    Modern inverter heat pumps are significantly quieter than traditional furnace blowers.

    No Gas Line Needed

    Eliminate gas line maintenance, leak risks, and monthly connection fees.

    How Full Electric Compares

    FeatureFull Electric HPGas Furnace + ACDual Fuel HPDuctless HP
    Heating & Cooling✅ Both✅ Both✅ Both✅ Both
    Zero Gas✅ Yes❌ No❌ No✅ Yes
    Energy Efficiency⭐⭐⭐⭐⭐⭐⭐⭐⭐⭐⭐⭐⭐⭐⭐⭐⭐⭐
    Whole Home via Ducts✅ Yes✅ Yes✅ Yes❌ Zone only
    Rebate Potential⭐⭐⭐⭐⭐⭐⭐⭐⭐⭐⭐⭐⭐
    Extreme Cold Backup⚠️ Electric strips✅ Gas furnace✅ Gas furnace⚠️ Baseboard

    Installation Process

    Every install follows a rigorous process. Here's a typical walkthrough.

    Old Lennox condenser before removal

    Step 1 — Site assessment: old Lennox condenser & gas furnace evaluated

    Team inspecting old gas furnace before removal

    Step 2 — Team inspects old gas furnace for removal planning

    Old gas furnace being removed

    Step 3 — Old furnace removal & gas line disconnection

    New Midea air handler installed with ductwork

    Step 4 — Midea air handler installation & duct connection

    Midea outdoor condenser during refrigerant commissioning

    Step 5 — Outdoor condenser placement & refrigerant line commissioning

    Completed Midea outdoor heat pump condenser

    Step 6 — Full system commissioning & performance verification

    Detail Close-Ups

    Neat, safe, and to code.

    Midea outdoor heat pump condenser on anti-vibration mounts

    Outdoor condenser — anti-vibration mounts and proper clearances

    Midea air handler with ductwork and SRMax controller

    Air handler — clean duct transitions with SRMax smart controller

    Midea smart thermostat showing temperature and humidity

    Midea smart thermostat — Wi-Fi enabled with humidity monitoring

    Lennox downflow gas furnace before Panasonic heat pump upgrade

    Lennox downflow gas furnace — before Panasonic full electric conversion

    Panasonic ducted heat pump air handler installed replacing gas furnace

    Panasonic air handler installed — replacing old Lennox gas furnace, fully electric

    Panasonic outdoor heat pump condenser with EnergyGuide label

    Panasonic outdoor condenser — cold-climate rated, whisper-quiet operation

    Quality Install Checklist

    Wall penetration sealed with fire-rated foam and sloped for drainage

    Copper line set properly flared, torqued, and insulated

    Vacuum pulled to 500 microns and held for 30+ minutes

    Condensate drain properly sloped with P-trap where required

    Electrical disconnect and dedicated circuit installed to code

    Line set cover installed for clean exterior finish

    System tested in heating and cooling modes before handover

    Homeowner walkthrough: remote control, filter cleaning, maintenance tips

    Example Upgrade Scenario

    Illustrative upgrade scenario — true before & after photos from the same space will be added as they become available.

    Old gas furnace before full electric heat pump conversion
    EXISTING

    Before — Old gas furnace in utility closet

    New Mitsubishi ZUBA full electric heat pump air handler installed
    UPGRADED

    After — Mitsubishi ZUBA full electric heat pump air handler, no gas required

    Technology & Trends

    Frequently Asked Questions

    Recent Projects

    Panasonic full electric heat pump outdoor condenser installed at a Metro Vancouver home

    Panasonic full electric upgrade — Lennox downflow gas furnace replaced with Panasonic ducted heat pump. Panasonic is a top-tier brand known for whisper-quiet operation, exceptional cold-climate performance down to -30°C, and industry-leading reliability. A premium choice worth every dollar.

    Metro Vancouver, BC
    Midea full electric heat pump conversion

    Gas-to-electric conversion — Midea air handler + condenser. Old Lennox replaced.

    Metro Vancouver, BC
    Fujitsu electric heat pump in Surrey BC

    Full electric upgrade — Fujitsu Halcyon inverter system.

    Surrey, BC
    TOSOT full electric heat pump installation

    TOSOT ducted heat pump install — air handler + condenser.

    Maple Ridge, BC

    Ready to Upgrade Your Comfort?

    Contact us for a free on-site assessment. No obligation, no pressure — just honest advice.